ERCD – Deviation Counter Clear Delay
Gets/sets the output pulse width [value] of the deviation counter direction signal for [axis].
Access: Read/Write
Category: Servo
Applies to: All Commander Controllers
ASCII ERCD[axis]
Syntax
Read
ERCD[axis]
|
Where: [axis] is set to X, Y, Z, U |
Write
ERCD[axis]=[delay]
|
Where: [axis] is set to X, Y, Z, U [delay] sets the OFF delay time (0-3) 0: 0 us 1: 12 us 2: 1.6 ms 3: 104 ms |
Reply 
Command is accepted and executed
Read
Returns the value set for delay time (0-3)
Write
OK
Command cannot be processed
An error message is returned. See Error Codes
Example
Read ERCDY * Returns the setting for the OFF delay time for the Y-axis
Write ERECZ=3 * Sets Z-axis deviation counter clear signal OFF delay time to 104 ms
Notes
See picture to understand interaction of error signal, ERC signal and the ERCD and ERCP settings.
See also
ERC, ERCP, INP, POL, SDC, SDE, EXST, IERR, STORE