Standalone can be configured to run on boot-up using the SLOAD command.  Once this command has been issued, the STORE command will be needed to save the setting to flash memory. It will take effect on the following power cycle. See description in the table below for the bit assignment of the SLOAD setting.

Bit

Description

0

Standalone Program 0 

1

Standalone Program 1 

2

Standalone Program 2

3

Standalone Program 3

SLOAD  command

ASCII

SACTRL[0-3]

SASTAT[0-3]

SPC[0-3]

GS[0-31]

V[0-99]

SLOAD

Standalone

SR[0-3]

⎯

⎯

GOSUB[0-31]

V[0-99]

⎯


ASCII

SAP

STORE

Standalone

⎯

STORE


<  Previous Chapter | Topic Home | Home | Next Topic >