The Commander core uses 3 x 50-pin connectors with 1.27mm pitch to allow access to all signals. In this manual – when viewing from the bottom, with the three sets of pins, left, right and bottom – we will refer to the left set of pins as CON1, the right set as CON2, and the bottom set as CON3. For the purpose of simplicity, in this manual, all pin numbers are referred to by CON number then pin number in the set. For example, pin 3 on CON1 will be referred to as pin 1-3, whereas pin 25 on CON3 will be referred to as pin 3-25.

Recommended Mating Connector Information

Manufacturer: FCI

Part Number: 20021311-00050T4LF

Other compatible 1.27mm connectors can be used. Figure in Section 6.2.1 Pin-out shows the Pin 1 locations.

<  Previous Chapter | Topic Home | Home | First Section | Next Topic >

This chapter is broken into the following sections and sub sections;

<  Previous Chapter | Topic Home | Home | First Section | Next Topic >