AO – Analog Output
Gets/sets the analog output [value] for [channel]
Access: Read/Write
Category: AnalogOut
Applies to: 2CR, 4CR, 4ED, 4EX, CM3, 8CR
ASCII AO[channel]
Standalone AO[channel]=[value]
Syntax
Read
AO[channel]
|
[channel] – specifies the output 2 analog 10-bit outputs [1-2] |
Reply
Command is accepted and executed
Write
AO[channel]=[value]
|
[channel] – specifies the output 2 analog 10-bit outputs [1-2] [value] – specifies the output voltage in mV (0-3,300) |
Write
OK
Command cannot be processed
An error message is returned. See Error Codes
Example
Read
AO1 * returns the value in mV of the voltage on the analog output for the X-axis
Write
AO2=500 * sets the analog output value to 500 mV for analog output 2
Notes:
This command is not fully working yet Leave as "OUT of DATE" status