3.2.1 Communication Port Settings

The Commander series of controllers has the communication port settings shown in table Serial port settings below.

Parameter	Setting
Byte Size	8 bits
Parity	None
Flow Control	None
Stop Bit	1

Serial port settings

Commander series of controllers provides the user with the ability to set the desired baud rate of the serial communication. In order to make these changes, first set the desired baud rate by using the DB command. By default, the Commander series of controllers has a baud rate setting of 9600 bps.

Return Value	Description
1	9600
2	19200
3	38400
4	57600
5	115200

DB command

To write the values to the device’s flash memory, use the STORE command. The new baud rate will now be written to memory, but will not go into effect until after a complete power cycle.

< Previous Section | Topic Home | Home | Next Section >